Welcome to Hengshui Jianfeng Engineering Rubber co., LTD.,

Bridge expansion joint welding

author: Jianfeng Engineering from: ԭ date: 2017/11/7 18:00:00 hit: 6149
Tips: The welding seam welding seam: telescopic expansion, expansion joint fixation on the elevation and r...

The welding seam welding seam: telescopic expansion, expansion joint fixation on the elevation and retest again, to determine any deformation, does not appear in the temporary fixed bias during the process, the anchor reinforcement and pre buried reinforced welded steel beam straight on both sides at the same time, any deviation, the deformation of anchor bars and pre specific steel beam buried reinforced welded on both sides at the same time, the best time to each. If there is difficulty, the first side of weld, to install a predetermined temperature, then the other side of all welding in the welding. If there is difficulty, the first side of weld, to install the preset temperature, then on the other side. At the same time all welded connection,M ruler, flatness detection of shaped steel beams. The feeler, then at the same time, using the 3 meter ruler at any time, flatness detection of shaped steel beams. The feeler gauge flatness control in 0 ~ 1mm, ~ to avoid jumping phenomenon. In order to avoid jumping phenomenon. The number of personnel configuration to be reasonable welding, welding to try to shorten the time, all in the welding process to be removed in time after the completion of welding personnel to clamp the reasonable configuration, to try to shorten the time of welding in the welding process, all the time after removal of fixture, lifting and hanging contraction joint joint device, relax after a comprehensive quality inspection, such as inconsistentThe requirements need to be re adjusted. After completion of welding steel banding. After completion of welding steel banding.

The bridge expansion joint is to meet the requirement of bridge deformation, usually between two beam end hinged position between the girder and the abutment or bridge set expansion joints. The expansion joints in parallel, two direction perpendicular to the axis of the bridge, can free expansion, firm and reliable, the vehicle should be smooth running out no, jump and noise; to prevent rainwater and waste soil infiltration obstruction; installation, inspection, maintenance, remove the dirt will be simple and convenient. In the setting of expansion joints, rail and bridge deck pavement are disconnected.

According to the joint performance and installation methods can be divided into: GQF-C type, GQF-Z type, GQF-D type, GQF-F type, GQF-MZL type and GQF-MZL type mode! The number of bridge expansion joint device, is the overall design of special-shaped steel bridge expansion joint device of hot rolling forming. The GQF-C type, GQF-Z type, GQF-D type, GQF-F type expansion joint bridge joint device is suitable for the expansion of the 80mm below the GQF-MZL type, GQF-160 type, GQF-240 type, GQF-320 type expansion joint device is composed of the side beam, inBeam, modular bridge expansion joints composed of crossbeam and linkage device, suitable for large and medium span bridge expansion of 80mm-1200mm.


  

contact us

TEL: +8613132415777
FAX: 86-318-8538660
Email: eric@prolianz.com
sales@prolianz.com
URL: http://www.prolianz.com
ADD: Hengshui City, Hebei Province, China

Copyright © 2016 Hengshui Jianfeng Engineering Rubber co., LTD., All Rights Reserved.
SITEMAP | XML | RSS